Dominion SX Frequently Asked Questions 1/9
Dominion
®
SX
How do I enable Direct Port
Access with a Dominion SX unit
running SX3.0 firmware?
Enabling Direct Port Access (DPA) from the CLI in Dominion SX3.0 -
Attached is a sample run for DPA configuration from CLI.
The following are main steps:
1. Configure DPA mode from Configuration->Services.
2. Configure which port need DPA and type of DPA (Telnet-
TCP, SSH-TCP, IP ADDR) from Configuration->ports
3. Reboot SX
4. Reapply Configuration-Services settings, for SSH, Telnet to
take effect of DPA settings.
5. Reboot SX
DPA should be functional on 2
nd
reboot
Why do I get a “This page
contains secure and insecure
items” prompt when using IE6?
This message may or may not be displayed, depending on the settings of IE6.
Why do I get an “Invalid
certificate message” when using
some browsers?
The Certificate Authority (CA) used by Raritan, Inc. may not be on the CA list
of the browser.
What is the purpose of the
Disable Local Authentication
option?
For security reasons, some users do not want to allow any locally
authenticated users to log into the Dominion SX unit. This option allows only
for remotely authenticated users to log into the Dominion SX unit. This option
should only be enabled AFTER remote authentication has been successfully
tested and configured.
When I Disable Local
Authentication, how come I
cannot log into the Dominion SX
unit?
This is because of a couple of reasons:
1) A valid remote authentication source has not been entered.
2) The remote authentication source is not reachable.
The Disable Local Authentication option should only be enabled AFTER
remote authentication has been successfully tested and configured.
Why do I lose connectivity to the
Dominion SX unit after resetting
it to factory default?
By default the unit in factory reset mode enables DHCP to get an IP address.
If there is no DHCP server, it will reset to the IP address 192.168.0.192 with
the username “admin” and password “raritan”.
What settings will be lost when
restoring a unit to factory
default?
All user-entered settings: usernames, passwords, all networking parameters –
including IP address, security profiles, firewall rules, all services, TCP port
numbers for services, idle logout timer, strong password rules.
Why does the Device disconnect
indication not work with all my
devices and servers?
Device disconnect indication requires both hardware (RS232) control signal
support, and the right serial cabling to work. If either of these is missing,
device disconnect indication cannot correctly track the loss of connection to a
serial device. Most, but not all, servers and devices support these control
signals.
Kommentare zu diesen Handbüchern